Airmail Setup Wizard

From Digital Traffic System
Jump to: navigation, search

The Set Up Wizard should run the first time you start the program. If it does not, do not be alarmed, all the settings may be entered manually.

  • Click Next
  • Enter your HAM System Callsign: use your callsign
  • Click Next
  • Enter your Latitude in degrees and minutes with a decimal, not seconds 32 33.11 N works for me
  • Enter your Longitude in degrees and minutes with a decimal, not seconds 092 11.60 W works for me. If you are in the US it is W and not E
  • Check Send Lat/Lon to station
  • Click Next
  • Select a Modem from the list for HF. If you are not going to use HF Pactor now, do not be alarmed. Select one as your HF modem (even if you do not have a HF modem). PTC-II PTC-IIe PTCIIex PTC-IIpro or Other ... PTC- DXP-38 MFJ-1278B MFJ-1276 DSP-2232 DSP-1232 PK-900 PK-232 KAM XL KAM 98 KAM Plus
  • Select Com Port the computer connects to the TNC
  • Select the Baud rate between the Com Port of the computer and the TNC. This is not the RF baud rate that the radio transmits and receives. Up to 9600 baud usually works for older computers and TNCs. Higher baud rates work for more modern computers and TNCs.
  • Click Next
  • Will you control your radio with the computer? If so, then select the correct radio Icom-M802 Icom-M710 Icom-M710RT Icom-700pro Icom CIV Kenwood Yaesu Yaesu 817 Yaesu 600 Furuno-1503 T-bus SEA-235 SGC-2000 Codan-9390 Orion
  • Select the Com Port and Baud rate for the computer connection to control the radio frequency. This is not the RF baud rate
  • Click Next
  • Click Finish